D-Link xStack Reference Guide

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
798
70-10 config snmp system_contact
Description
This command is used to enter the name and/or other information to identify an SNMP system
contact person who is responsible for the switch. A maximum of 255 characters can be used.
Format
config snmp system_contact <sw_contact>
Parameters
<sw_contact> - Enter an SNMP system contact person. A maximum of 255 characters is
allowed.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the switch contact to “ MIS Department IV ”:
DGS-3620-28SC:admin#config snmp system_contact "MIS Department IV"
Command: config snmp system_contact "MIS Department IV"
Success.
DGS-3620-28SC:admin#
70-11 enable snmp traps
Description
This command is used to enable SNMP trap support on the switch.
Format
enable snmp traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable SNMP trap support:

D-Link xStack Specifications

General

Brand	D-Link
Model	xStack
Category	Switch
Language	English