xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
683
Message TX Hold Multiplier: 4
ReInit Delay : 2
TX Delay : 2
Notification Interval : 5
57-5 config lldp forward_message
Description
This command is used to configure LLDP forwarding messages. When LLDP is disabled and
LLDP forward message is enabled, the received LLDPDU packet will be forwarded. The default
state is disabled.
Format
config lldp forward_message [enable | disable]
Parameters
enable - Enable LLDP forwarding messages.
disable - Disable LLDP forwarding messages.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable LLDP forwarding messages:
DGS-3620-28SC:admin#config lldp forward_message enable
Command: config lldp forward_message enable
Success.
57-6 config lldp notification_interval
Description
This command is used to configure LLDP timer values. This will globally change the interval
between successive LLDP change notifications generated by the switch.
Format
config lldp notification_interval <sec 5-3600>
To Next Page
Loading...
Need help?
General