xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
805
70-21 config trap source_ipif
Description
This command is used to force change the ipif information in trap messages. By default, trap
messages will carry the information of the ipif they belong to.
Format
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name. If only this parameter is specified, the IPv4
address and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specify the IPv4 address.
<ipv6addr> - (Optional) Specify the IPv6 address.
none - Specifies to clear the configured source IP interface.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the trap source IP interface:
DGS-3620-28SC:admin#config trap source_ipif inter4
Command: config trap source_ipif inter4
Success.
To clear the configured trap source IP interface:
DGS-3620-28SC:admin#config trap source_ipif none
Command: config trap source_ipif none
Success.
70-22 show trap source_ipif
Description
This command is used to display the trap source IP interface.
Format
show trap source_ipif
To Next Page
Loading...
Need help?
General