D-Link xStack Reference Guide

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
823
DGS-3620-28SC:admin#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host 1
IP Address : 10.1.1.2
Severity : Warning
Facility : Local10
UDP port : 514
Status : Disabled
Host 2
IP Address : 3000:501:100:ffff:101:202:303:1
Severity : Emergency
Facility : Local10
UDP port : 514
Status : Disabled
Total Entries : 2
DGS-3620-28SC:admin#
71-19 config syslog source_ipif
Description
This command is used to force change the ipif information in syslogs. By default, syslogs will carry
the information of the ipif they belong to.
Format
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name. If only this parameter is specified, the IPv4
address and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specify the IP4 address.
<ipv6addr> - (Optional) Specify the IPv6 global address.
none - Specifies to clear the configured source IP interface.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the syslog source IP interface:
DGS-3620-28SC:admin#config syslog source_ipif Sysetm
Command: config syslog source_ipif System

D-Link xStack Specifications

General

Brand	D-Link
Model	xStack
Category	Switch
Language	English