Dahua NVR6000 Series User Manual

Parameter Function
Alarm Out Please select corresponding alarm output channel when an alarm
occurs. You need to check the box to enable this function.
Latch The alarm output can delay for the specified time after an alarm stops.
The value ranges from 1s to 300s.
Show
message
System can pop up a message to alarm you in the local host screen if
you enabled this function.
Alarm
upload
System can upload the alarm signal to the centre (Including alarm
centre.
Send
Email
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Buzzer Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
4.8.3.6 Alarm Output
From main menu-> Setup->Event->Alarm output, it is to set alarm output mode. See Figure 4-71.
Figure 4-71
4.8.4 Storage
4.8.4.1 Schedule
From main menu-> Setup->Storage->Schedule, you can go to the schedule interface. In this interfaces,
you can add or remove the schedule record setup. See Figure 4-72.
There are five record modes: Regular, motion detect, alarm and MD&alarm, and intelligence. There are
six periods in one day.
You can view the current time period setup from the color bar.
 Green color stands for the general record/snapshot.
 Yellow color stands for the motion detect record/snapshot.
 Red color stands for the alarm record/snapshot.
 Blue color stands for MD&alarm record/snapshot.
 Orange color stands for intelligent record/snapshot.
184

Dahua NVR6000 Series Specifications

General

Brand	Dahua
Model	NVR6000 Series
Category	Network Hardware
Language	English