Danfoss VLT AutomationDrive FC 302 Service Guide

10.2.6 Mains Input Terminal Block
To remove or reinstall the mains input terminal block, use the following steps. Refer to Illustration 10.6.
Disassembly
1. Disconnect any customer input power wiring, and
remove the R/S/T terminal label.
2. Remove the AC input busbars. Refer to
chapter 10.2.5 AC Input Busbars.
3. Remove 2 screws (T25) at the bottom of the
terminal block.
4. Remove the terminal by sliding it down to
disengage it from the 2 metal retaining clips on
the mounting plate. It can be necessary to
remove 1 screw (T25) from the EMC shield when
removing the terminal block.
Reassembly
Tighten hardware according to chapter 14.1 Fastener Torque
Ratings.
1. Place the terminal in its original position by
sliding it under the 2 metal retaining clips.
2. Secure 2 screws (T25) at the bottom of the
terminal block.
3. Replace the AC input busbars. Refer to
chapter 10.2.5 AC Input Busbars.
4. Reconnect any customer input power wiring, and
replace the R/S/T terminal label.
D1h/D3h/D5h/D6h/J8 Drive Di...
VLT
®
FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
138 Danfoss A/S © 02/2019 All rights reserved. MG94A502
1010

Danfoss VLT AutomationDrive FC 302 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 302
Category	DC Drives
Language	English