12.3 Parallel Drive Module Disassembly and Assembly
12.3.1 General Information
The instructions in this chapter include procedures for disassembly of parallel drive systems in IP00 enclosures. The parallel
drive modules within the systems are similar to the D3h/D4h drives described in previous chapters. Instead of an individual
control card, the VLT® Parallel Drive Modules have a blank mounting plate and are controlled by the MDCIC. The
disassembly of the blank mounting plate is described in this chapter. For other disassembly procedures, refer to Table 12.2.
Parallel drive system Parallel drive module disassembly instructions
Da2 system Refer to chapter 10 D1h/D3h/D5h/D6h/J8 Drive Disassembly and Assembly.
Da4 system Refer to chapter 10 D1h/D3h/D5h/D6h/J8 Drive Disassembly and Assembly.
Db2 system Refer to chapter 11 D2h/D4h/D7h/D8h/J9 Unit Disassembly and Assembly.
Db4 system Refer to chapter 11 D2h/D4h/D7h/D8h/J9 Unit Disassembly and Assembly.
Table 12.2 Additional Disassembly Instructions
Da2/Db2/Da4/Db4 Parallel Sy... Service Guide
MG94A502 Danfoss A/S © 02/2019 All rights reserved. 255
12 12
To Next Page
Loading...
Need help?
General