Danfoss vlt FC 102 Installation Guide

5.7.3.3 Motor Terminal Connections in 4-Drive Module Systems 27
5.8 Mains Connections
28
5.8.1 AC Mains Terminal Connections 28
5.8.1.1 Mains Terminal Connections in 2-Drive Module Systems 28
5.8.1.2 Mains Terminal Connections in 4-Drive Module Systems 29
5.8.2 12-Pulse Disconnector Conguration 29
5.8.3 Discharge Resistors 30
5.9 Control Shelf Installation
31
5.10 Control Wiring Connections
31
5.10.1 Control Cable Routing 32
5.10.2 Control Wiring 33
5.10.2.1 Control Terminal Types 33
5.10.2.2 Wiring to Control Terminals 35
5.10.2.3 Enabling Motor Operation (Terminal 27) 35
5.10.2.4 Voltage/Current Input Selection (Switches) 35
5.10.2.5 RS485 Serial Communication 36
5.10.3 Safe Torque O (STO) 36
5.11 Relay Output
36
5.12 EMC Recommendations
37
6 Initial Start-up
41
6.1 Pre-start Check List
41
6.2 Safety Instructions
42
6.3 Applying Power
42
6.4 Conguring the Drive System
43
6.5 Testing the Motor Operation
44
7 Specications
45
7.1 Power-dependent Specications
45
7.2 Mains Supply to Drive Module
59
7.3 Motor Output and Motor Data
59
7.4 12-Pulse Transformer Specications
59
7.5 Ambient Conditions for Drive Modules
59
7.6 Cable Specications
60
7.7 Control Input/Output and Control Data
60
7.8 Kit Dimensions
64
7.9 Fastener Tightening Torques
66
7.9.1 Tightening Torques for Terminals 66
8 Appendix
67
8.1 Disclaimer
67
Contents
VLT
®
Parallel Drive Modules
2 Danfoss A/S © 08/2017 All rights reserved. MG37K302

Danfoss vlt FC 102 Specifications

General

Brand	Danfoss
Model	vlt FC 102
Category	DC Drives
Language	English