8 Appendix
8.1 Disclaimer
Danfoss shall have no obligation with respect to any
product that
•
is not installed according to the standard congu-
ration as specied in the installation guide.
•
is improperly repaired or altered.
•
is subjected to misuse, negligence, and improper
installation where the guidelines were not
followed.
•
is used in a contradictory manner to the
instructions provided.
•
is a result of normal wear and tear.
8.2 Symbols, Abbreviations, and
Conventions
°C
Degrees Celsius
°F
Degrees Fahrenheit
AC Alternating current
AWG American wire gauge
DC Direct current
EMC Electro magnetic compatibility
ETR Electronic thermal relay
FC Frequency converter
IP Ingress protection
LCP Local control panel
MCT Motion control tool
MDCI
C
Multi-drive control interface
PCB Printed circuit board
PELV Protective extra low voltage
PM
Motor
Permanent magnet motor
RCD Residual current-operated protective device
Regen Regenerative terminals
RFI Radio frequency interference
RPM Revolutions per minute
Table 8.1 Symbols and Abbreviations
Conventions
Numbered lists indicate procedures.
Bullet lists indicate other information and description of
illustrations.
Italicized text indicates:
•
Cross-references.
•
Links.
•
Parameter names.
All measurements are given in both metric units and
imperial units. Imperial units are in ( ).
Appendix Installation Guide
MG37K302 Danfoss A/S © 08/2017 All rights reserved. 67
8 8
To Next Page
Loading...
Need help?
General