To Next Page

To Previous Page

84 Supplies and Parts

Cards

Forbestresults,usehigh‐qualitycardsthatmeetthespecificationsand

recommendationsdescribedinthissection.

Card Size

UseISOID‐1cards(CR80cards).Thesecardshavethefollowingdimensions:

• 3.37incheslongby2.125incheswide(85.60mmlongx53.98mmwide).

• 0.010to0.030inchesthick(0.254mmto0.762mmthick).

Forencodingmagneticstripe,use cards:

• 3.37incheslongby2.125incheswide(85.60mmlongx53.98mmwide).

• 0.010to0.030inchesthick(0.508mmto0.762mmthick).

Actualcardthicknesscanvarybyuptotenpercentfromthesizeslisted.Typically,

cardbowmustbelessthanthethicknessofthecard.

Card Material

UsecardswithaglossyPVCsurface,either100%PVCcardsorcompositecards

withaPVCsurface.Cardscanhaveamagneticstripeononesideofthecard.

Pre-Punched Cards

Forbestresults,punchcardsafter

printingthem.Thecardscanhave

apunchedareawithin1inch

(25 mm)oftheleftedge,asthe

cardsareloadedintheprinter.If

thecardhasamagneticstripe,

thecardcannotbepunched

anywhereinthestripe.

DataCard SD260LTM Installation And Administration Guide

Other manuals for DataCard SD260LTM