Systems Manual 39
Return to Factory Settings
Scan the bar codes below in sequence to return the scanner to the
default settings configured at the factory. This label is typically used to
return the RF unit to a “known” operating state when the present pro-
gramming status is not known, faulty, or suspect.
If you don’t have a record of your site/system’s original configuration,
you may need to contact your sale representative for assistance to
return the unit to normal function. Please be prepared to provide infor-
mation about the company, location, host terminal system and other
pertinent information about the unit being repaired.
Feature is applicable to scanner and Base Station.
CAUTION
Use this bar code with caution, since it will
reset ALL features that may have been pro-
grammed for that interface type since the RF
unit’s installation.
SET --------------------------
Return to Factory
Setting
END --------------------------
Transmit Scanner
Configuration to Base
Station
To Next Page
Loading...
Need help?
General
