To Next Page

To Previous Page

Systems Manual 45

RF Beeper

Settings

The RF version of the scanner exhibits different beeper behavior than

standard (non-RF) models. For more information about RF beeper indi-

cations, see the section, LED and Beeper Indications.

Good Read Beep — When good read beep is enabled, this beep sounds

at the time the scanner successfully reads a bar code. Selectable settings

for the good read beep include:

• RF When to Beep

• Beeper Volume

• Good Read Beep Frequency

• Beep Duration

ACK Beep — The scanner can sound an acknowledgement (ACK)

beep to indicate when the Base Station has acknowledged to the scan-

ner that is has received a successful data transmission from the scanner.

This beep is also sounded upon a successful channel change sequence

or a successful configuration transmission.

Transmission Error Beep — Another selectable indicator beep is the

transmission error beep. This beep sounds to indicate an error in trans-

mission between the RF devices.

Link Beep — The handheld scanner will sound a special link beep

upon successfully linking with a Base Station. This indication cannot be

disabled and is not programmable, other than that it shares the same

Beeper Volume setting as other beeper indications set using that fea-

ture.

Unlink Beep — When a scanner is successfully unlinked from a Base

Station, a unique unlink beep is sounded. This beep is not programma-

ble, and also sounds at the same volume set for Beeper Volume.

NOTE

The following descriptions highlight configurable

beeper functions that are unique to RF handheld

scanners. All other beeper functions supported by

the standard version of the scanner are supported

by RF models.

Datalogic PowerScan RF User Manual

Other manuals for Datalogic PowerScan RF