Demo Mode
This setting contains a built-in demonstration mode. The settings allow you to turn the Demo Mode Off (default)
or On. While Demo Mode is set, the printer will start in Demo Mode until you change the setting.
Note: While Demo Mode is set to On, only demonstration files can print. Files received across the network or
from the host computer are ignored.
Factory Defaults
This setting enables a user to restore all the printer settings to the original factory settings. The selections are
Do not restore (default) and Restore now. Network does not appear unless you have a network printer. The
following settings are not changed:
• Display language
• Settings in the NETWORK/PORTS MENU group.
Energy Conserve
This menu controls what values appear on the Power Saver menu. If Off is selected in the Energy Conserve
menu, then the Power Saver can be turned off. If On (default) is set in Energy Conserve, then the Power Saver
feature cannot be turned off.
Font Sharpening
This menu allows a user to set a text point-size value below which the high frequency screens will be used when
printing font data. For example, if this setting’s value is “24,” then all fonts sized 24 points or less will use the
high-frequency screens. To increase this setting’s value by 1, press . To decrease this setting’s value by 1,
press .
Exit Configuration Menu (Exit Config Menu)
Press to exit the Configuration menu. The printer performs a POR and restarts in normal mode.
3-4
To Next Page
Loading...
Need help?
General
