Installing Accessories
Precautions When Installing Printer Accessories
Installing Printer Memory
Installing USB Font Card
Installing Optional Tray
Installing High Capacity Feeder
Using the hard disk
Installing an Output Expander.
Precautions When Installing Printer Accessories
Never remove the control board cover while the printer is plugged in.
To avoid the possibility of an electrical shock, always disconnect the power cord when installing or removing ANY internal or external printer option.
The control board and internal accessories (wireless network interface card, DIMM, and hard disk) are sensitive to static electricity. Before installing or
removing internal accessories, discharge static electricity from your body by touching something metal, such as the metal back plate on any device plugged
into a grounded power source. If you walk around before finishing installation, discharge any static electricity once again.
Installing Printer Memory
Additional printer memory is provided on a Dual In-line Memory Module (DIMM).
The Dell 5330dn Mono Laser Printer has 256 MB of memory. It can be expanded to 768 MB.
1. Power the printer off and unplug all cables from the printer.
2. Grasp the control board cover and remove it.
3. Remove a new memory DIMM from its antistatic package.
4. Locate the extra DIMM slot and align the notch on the DIMM with the groove at the DIMM slot, holding the DIMM by its edges.
To Next Page
Loading...
Need help?
General