Dell EMC PowerEdge R6525 User Manual

Figure 123. Installing the intrusion switch module
Next steps
1. Install the expansion card riser.
2. Follow the procedure listed in After working inside your system.
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the expansion card riser.
Steps
1. Open the blue latch to unlock the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
134
Installing and removing system components

Dell EMC PowerEdge R6525 Specifications

General

Brand	Dell
Model	EMC PowerEdge R6525
Category	Server
Language	English