Installing the Secure Digital card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Steps
Push the SD memory card out into its slot to insert it.
Next steps
1. Follow the procedure in After working inside your computer.
Base cover
Removing the base cover
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
About this task
NOTE: Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following images indicate the location of the base cover and provide a visual representation of the removal procedure.
Removing and installing Customer Replaceable Units (CRUs)
39
To Next Page
Loading...
Need help?
General
