Power supply connector
The following table lists the Power supply connector specifications of your OptiPlex All-in-One 7410.
Table 17. Power supply connector
160 W internal power supply unit (PSU), 80 Plus Bronze
● One 8-pin connector for processor
● One 6-pin connector for system board
● One 6-pin connector for control signal
● One 2-pin connector for LED
Display
The following table lists the display specifications of your OptiPlex All-in-One 7410.
Table 18. Display specifications
Description Option one Option two
Display type
Full High Definition (FHD), ComfortView
Plus
Full High Definition (FHD), ComfortView
Plus
Touch options
No Touch support, with 10 touch points
Display-panel technology
In-Plane Switching (IPS) In-Plane Switching (IPS)
Display-panel dimensions (active area):
Height
296.46 mm (11.67 in.) 296.46 mm (11.67 in.)
Width
527.04 mm (20.75 in.) 527.04 mm (20.75 in.)
Diagonal
604.70 mm (23.81 in.) 604.70 mm (23.81 in.)
Display-panel native resolution
1920 x 1080 1920 x 1080
Luminance (typical)
250 nits 300 nits
Megapixels
2.07 2.07
Color gamut
99% (sRGB) 99% (sRGB)
Pixels Per Inch (PPI)
92 92
Contrast ratio (min.)
● 700:1, minimum
● 1000:1, typical
● 700:1, minimum
● 1000:1, typical
Response time (max.)
● 25 ms, minimum
● 14 ms, typical
● 20 ms, minimum
● 14 ms, typical
Refresh rate
60 Hz 60 Hz
Horizontal view angle
● +/- 85 degrees, minimum
● +/- 89 degrees, typical
● +/- 85 degrees, minimum
● +/- 89 degrees, typical
Vertical view angle
● +/- 85 degrees, minimum
● +/- 89 degrees, typical
● +/- 85 degrees, minimum
● +/- 89 degrees, typical
Pixel pitch
0.27 mm 0.27 mm
30 Specifications of OptiPlex All-in-One 7410