Delta EnviroStation EMS2000 User Manual

Chapter 2 : Introduction
8
No.
Item Description
 Off: The Digital Input is defined as ‘None’ or ‘Information’.
❻
Sensor
HUB
LEDs
 On (yellow): The Sensor HUB is activated and defined as
‘Warning’ or ‘Alarm’.
 Off: The Sensor HUB is defined as ‘None’ or ‘Information’.
❼
10/ 100
Base-T
Network
Port
Connects the EnviroStation to the network.
1. When the EnviroStation initializes or upgrades its firmware,
the two LED indicators on the 10/ 100 Base-T network port
flash simultaneously. Please refer to the following for LED
illumination definition.
 Rapid simultaneous flashing (every 50ms):
Initialization or firmware upgrade in progress.
 Slow simultaneous flashing (every 500ms):
Initialization failure.
W
arning：
Do NOT disconnect the EnviroStation’s input power
during initialization or firmware upgrade! This could
result in data loss or damage to the EnviroStation.
2. The green LED indicator shows the network connection
status:
 ON: Network connection established and the IPv4
address is useable.
 OFF: Not connected to a network.
 Flashes slowly (every 500ms): Faulty IP address.
3. The yellow LED indicator shows the linking status:
 Flashes rapidly (every 50ms): Linking normal.
 Flashes slowly (every 500ms): Linking abnormal.
❽
Console
Port
Connects to a workstation with an RJ45 to DB9 cable.
❾
Reset
Button
Resets the EnviroStation’s network module. This will not affect
the operation of other connected devices.
❿
Modbus
RS485 port
Connects devices to EnviroStation via the Modbus protocol.

Delta EnviroStation EMS2000 Specifications

General

Brand	Delta
Model	EnviroStation EMS2000
Category	Control Unit
Language	English