InfraSuite EnviroStation 17
3.7. Relay Output
EnviroStation provides two Relay Outputs which can be
used in cooperation with Digital/ Analog Input devices to take
appropriate actions when events are reported.
The power rating is 26Vdc, 0.8A. Please see the following
illustrations for the terminal configurations:
3.8. Alarm Beacon
The Alarm Beacon can be installed in visible locations and triggered by specific
events to alert you to any unusual situations. To install the Alarm Beacon, a provided
terminal block and a Sensor HUB adapter are needed.
Step 1 Plug the terminal block into the green terminal connector of the Sensor
HUB adapter.
Step 2 Connect the positive wire (+) from the Alarm Beacon to the 12V terminal
on the terminal block, and the negative wire (-) to the G (12V) terminal.
Make sure that the screws on the connected terminals are tightened
properly.
Step 3 Use a standard CAT5 cable to connect the RJ45 connector of the adapter
to the Sensor HUB1/ HUB2 on the rear panel of the EnviroStation.
To Next Page
Loading...
Need help?
General
