InfraSuite EnviroStation 33
Chapter 5 : InsightPower SNMP IPv6 for EnviroStation Web
To configure EnviroStation via the InsightPower SNMP IPv6 for EnviroStation Web,
please follow the steps below:
Step 1 Make sure that your EnviroStation is connected to the LAN. Use a
standard CAT5 cable to connect the EnviroStation’s 10/ 100 Base-T
Network Port on the rear panel to your network.
Step 2 Launch your web browser. Enter EnviroStation’s Host Name
http://InsightPower or IP address http://192.168.1.100/ in the address
bar. For encrypted connection, enter https://InsightPower or https:
//192.168.1.100.
Step 3 When connection is established, the EnviroStation Login page appears.
Enter your account and password (Default: admin/ password).
NOTE:
1. If you have previously changed EnviroStation’s Host Name or IP address,
make sure to provide the correct information accordingly.
2. If the login page is accessible, but you are unable to log in with correct
account and password, additional network configuration is needed. The
cause could be the IP subnet of the computer you are logging in to is
different from the EnviroStation’s. To solve this issue, please refer to
Chapter 7: Troubleshooting Q3.
3. EnviroStation will automatically log off idle connections after 30 minutes.
To Next Page
Loading...
Need help?
General
