27
IP2251EN
Display Description
Selections
available
EA - Total memory deletion
→→
→
2”
ENTER
2”
ENTER
RE - Setting memory opening from remote control
OF - Disabled
ON - Enabled When enabled (ON), the remote programming is activated.
To store new remote controls without using the control panel, refer to the remote
control instructions.
NOTE: make sure you do not accidentally memorise unwanted remote controls.
EP -Setting the coded area messages
If the possibility to receive coded messages is enabled, the control panel
will be compatible with remote controls of the “ENCRYPTED” type.
MS - Backward compatibility setting with older generation GOL4 remote controls.
NOTE: firmware version 1.6.5 or higher is required.
OF - Compatibility with old generation GOL4 and new ZEN remote controls.
ON - Compatibility with ZEN series remote controls
NOTE: MS=ON is recommended if only ZEN series remote controls are used
on the system.
RO - Radio operations
11.6 Second level menu - SF (Special Functions)
Display Description
CU - Visualisation of the firmware version on the control panel
→→→ Release 1.1 [esempio]
ENTER
SV - Saving user configuration on control panel storage module.
ENTER UP DOWN
2”
ENTER
[esempio]
→→
/
→→→
By selecting → → you can save up to 2 personalised configurations
in memory positions
and only with the storage module present on the
control panel.
WARNING: if
→ → is selected, no user configuration can be saved
on
and .
WARNING: if the display visualises
flashing, the memory module may
not be installed.
Selections
available
RC - Configuration loading
ENTER UP DOWN
2”
ENTER
[esempio]
→→
/
→→→
It's possible to load the user configurations previously stored and on
the memory module of the control panel.
RL - Loading of last configuration set
→
→
2”
ENTER
The control panel automatically saves the last configuration set, and keeps it memorised in
the storage module.
In the event of a fault or the replacement of the control panel, the last configuration of the auto-
mation can be restored by inserting the storage module and loading the last configuration set.
SF - Special Functions
Release 1.1 (example)
(example)
(example)
To Next Page
Loading...
Need help?
General
