4. Tick the Enable Wi-Fi tick box.
Note If the controller cannot enable Wi-Fi, re-start the controller and navigate back
to this screen.
5.
Select Scan and wait for a list of available Wi-Fi networks to be displayed.
6.
Select
Properties next to the network to connect to.
7. Enter a valid network security key.
8. Tick the Set as default tick box, to use the selected network as the default network to
automatically connect to.
9. Select Connect.
10.
If the connection is successful, the Connections icon will turn green.
End of procedure.
Protocol Settings
Dynamark
Note
Gx-Series Dynamark protocol is fully backward compatible with the G-Series
Dynamark protocol.
To enable the Dynamark protocol:
1.
Select Home > Setup > Printer network > Protocol settings.
2.
Change the Protocol setting drop down to Dynamark.
INSTALLATION
EPT053091 - Issue 5 - 07 May 2021 90
To Next Page
Loading...
Need help?
General
