Setting and Unsetting
Page 14
“S>U” = change set to unset
“PB/C/D>U” = change part set B/C/D to unset
d) Repeat steps b) and c) as required.
e) Press .
5. The system unsets.
6. If you see a fault warning such as:
a) Press to acknowledge the warning.
b) Contact your installer for assistance.
Using a two-way keyfob-style remote control
The two-way remote control (Figure 2) can be used to set and unset the
system, query the current set/unset status of the system or operate a User-
Defined output. Each remote control has a unique electronic identity and is
assigned (page 34) to a specific user.
The remote control is designed to provide feedback about the current
status of the system (if enabled by the installer). When you operate the
buttons, the control unit sends back signals that light up one or more LEDs
on the fob. These show whether your system has set, or if there has been
an alarm while you have been away.
Figure 2. Two-way remote control buttons
In a partitioned system, the remote control can be used for only one
partition.
Part Set (part set
programmable)
To Next Page
Loading...
Need help?
General
