User Menu Options
Page 42
Testing the on-board keypad
(i-on Compact only.)
To carry out the test:
1. Select Test – On-board Keypad. You will see:
When you start the test, the LEDs around the navigation should all
glow red, and A, B, C and D glow alternately. Every time you press a
navigation key, the LEDs change colour.
2. Press , , and in turn to test the navigation keys. Each time
you press a key, the display should show the key you pressed.
3. Press both HUA keys at the same time. The display should confirm
that you pressed the HUA keys. An HUA alarm is not generated.
4. Press any other key to test it. The display should confirm the key you
pressed.
5. Press to finish the test.
Performing a walk test
Master and admin users can use Test – Walk Test to test detectors without
starting an alarm. Walking past motion detectors should be enough to
trigger them. If you have detectors connected to doors or windows, you will
have to open them to trigger those detectors.
During the test, if the detector is working, the control unit sounds a
confirmation tone and indicates that the detector has passed the test.
To carry out the test:
1. Select Test – Walk Test. The following is displayed:
2. Press or to select one of the following:
Once Causes a single chime for each zone that is triggered
during the walk test.
Off Switches off chiming.
On Generates a chime every time a zone is triggered.
To Next Page
Loading...
Need help?
General
