User Menu Options
Page 55
by On Time (see below). When set to Yes, the output
changes state every time a user operates the output, or
according to a schedule if you specify On Time, Off Time
and Days (see below).
On Time/Off Time/Days
If Latched is set to No, use On Time to specify the number
of seconds you want the output to remain active. If you
specify zero seconds, the output will not operate.
You can use On Time, Off Time and Days to specify a
schedule for the output to activate and deactivate
automatically. Use On Time and Off Time to specify the
time you want the output to activate and deactivate. Use
Days to specify the days of the week you want the output to
operate (use or to display each day, then or to
choose Yes or No).
Note: If a user activates the output while it is deactivated,
the output stays activated until the control unit reaches the
next off time. If a user de-activates the output while it is
activated, the output deactivates until the control unit
reaches the next on time.
Leave On Time, Off Time and Days without values if you
want the output to act as a simple on/off switch.
Press when you have finished editing On Time/Off
Time/Days.
Managing remote controls
You can use System Config – Remotes to specify the functions that can be
carried out using remote controls. The System Config – Remotes menu
contains the following options:
Edit Used to edit the programming of the buttons, such as
the buttons used to set or unset the system, or operate
outputs.
Delete Deletes a selected remote control.
Delete All Deletes all remote controls.
Unset Enables or disables the ability for all remote controls to
unset the system.
To Next Page
Loading...
Need help?
General
