User Menu Options
Page 54
3. Press or followed by to select one of the following options:
Name Select this to edit the name of the recipient. See
page 30 for details of how to enter text.
Tel No 1 The first telephone number of the recipient.
Tel No 2 The second telephone number of the recipient.
Note: The Email and IP Address settings are not used, as email
addresses (for emailed alarms) and IP addresses (for ARC reporting
over the internet) are configured and used by SecureConnect.
Press when you have finished editing the setting, and if required,
select another setting to edit.
4. Press several times to exit.
Editing outputs
You can use System Config – Edit Outputs to edit the on and off times of
any output the installer has configured as "User Defined".
Note: User-defined outputs can be activated or deactivated at any time
using Outputs On/Off (see page 61).
To edit an output:
1. Select System Config – Edit Outputs.
The first output you are able to edit is displayed:
The top line shows the address and type of the output. In the above
example, the address is PAN>01 and the type is W (wired). The
output type is displayed for control units that have built-in radio and
wired outputs. The bottom line shows the name of the output.
2. Press or followed by to select the output you want to edit.
3. Press or followed by to select the setting to change:
Name You can edit the name of the output. See page 30 for
details of how to enter text.
Latched Use or followed by to select Yes or No. When set
to No, the output changes state when activated, but then
returns to the normal state again after the period specified
To Next Page
Loading...
Need help?
General
