User Menu Options
Page 45
The keypad gives a double-beep confirmation tone and you will see
the results of the test:
The top line shows the number of the device, the button you pressed,
and the name of the user the device is allocated to. The bottom line
shows the function of the button and the strength of the signal. If the
signal strength is less than 4, contact your installer.
3. Repeat step 2 for the other buttons. Note: If you wish to test the Hold-
Up Alarm buttons, make sure you press them both at the same time.
4. Press to end the test.
Testing social-care or medical pendants
Master and admin users can use Test – Pendants to test social-care or
medical pendants.
To carry out the test:
1. Select Test – Pendants.
2. Press the button on the device you wish to test. The control unit gives
a double-beep confirmation tone and you will see the results of the
test:
The top line shows the name of the user the device is allocated to.
The next line shows the function of the device, and the third line
indicates the strength of the signal. If the signal strength is less than 4,
contact your installer.
3. Repeat step 2 for the other buttons.
4. Press to end the test.
To Next Page
Loading...
Need help?
General
