Page ii
© Eaton 2022
The information, recommendations, descriptions and safety notations in this document are
based on Eaton Corporation’s (“Eaton”) experience and judgment and may not cover all
contingencies. If further information is required, an Eaton sales office should be consulted.
Sale of the product shown in this literature is subject to the terms and conditions outlined in
appropriate Eaton selling policies or other contractual agreement between Eaton and the
purchaser.
THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR
MERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET OUT IN ANY EXISTING
CONTRACT BETWEEN THE PARTIES. ANY SUCH CONTRACT STATES THE ENTIRE
OBLIGATION OF EATON. THE CONTENTS OF THIS DOCUMENT SHALL NOT BECOME
PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES.
In no event will Eaton be responsible to the purchaser or user in contract, in tort (including
negligence), strict liability or other-wise for any special, indirect, incidental or consequential
damage or loss whatsoever, including but not limited to damage or loss of use of equipment,
plant or power system, cost of capital, loss of power, additional expenses in the use of existing
power facilities, or claims against the purchaser or user by its customers resulting from the use
of the information, recommendations and descriptions contained herein. The information
contained in this manual is subject to change without notice.
Compliance Statement
The i-on range of control units are:
Suitable for use in systems designed to comply with PD6662:2010 at Grade 2, and
environmental class II. The i-onG3MM is also designed to comply with PD6662:2017 at
Grade 3.
Suitable for use in systems designed to comply with the requirements of EN50131-3 at
Grade 2, and environmental class II. The i-onG3MM is also designed to comply with the
requirements of EN50131-3 at Grade 3.
Compliant with the requirements of EN50131-6:2008 at Grade 2 and environmental
class II. The i-onG3MM is also designed to comply with the requirements of EN50131-
6:2008 at Grade 3 .
If the installer selects a non-compliant configuration, they must remove or adjust compliance
labelling.
Warning: Mains voltages are present inside control unit. No
user serviceable parts inside.
To Next Page
Loading...
Need help?
General
