Quick Panel Operator User Manual Section 3
GFK-2847AA Jan 2023
Software 19
Note: Depending on set options, the update may or may not be enabled, or may update automatically. If
there is more than one flash device with a valid project copy present, a Select Media confirmation
window displays, prompting you to choose with which flash device to update Select the device from
the list and click OK to continue. When a valid project is found on the flash device, you will be
prompted to install the project or skip it. Tap OK to install or Cancel to skip the installation,
and continue to restart. If an invalid project is found, an error message displays. This window
must be closed before the unit will restart.
3.
Remove the flash device from the port.
3.6 FTP Server
The File Transfer Protocol (FTP) server included with the QuickPanel
+
unit
supports standards (RFC 959). It does not support Secure File Transfer
Protocol (SFTP) or implicit FTPS, which uses different ports and is based
on Secure Shell (SSH) rather than Secure Sockets Layer (SSL).
The FTP server is configured with the Quick Panel
+
Setup Tool. By default,
the server is not enabled. Once enabled, a background program will run,
waiting for clients to connect. Up to ten connections are supported.
Sessions that are idle for five minutes are terminated by the server.
The server supports the non-secure operation. All information including
username, password, and data is transmitted with no encryption and is
susceptible to packet sniffing and various FTP attacks.
Note: If the server status is changed, the QuickPanel
+
must be restarted before changes take effect.
3.6.1 Remote User Authentication
Note: The FTP root directory is available from the QuickPanel
+
as \, and is the root of the flash device.
The server only supports anonymous login with a password requested
(but not validated). This may prevent some types of attacks and is
required by some clients. Once connected, the remote user is logged into
the FTP root directory.
3.6.2 FTP with Removable Flash Devices
All removable flash devices remote-FTP users as directories of the FTP
root directory. Computer Flash card partitions display as directories such
as \SD Memory and USB Flash Keys display as directories such as \Hard
Disk. Full access privileges are granted to the client in these
folders/devices.
Removable flash device directories are captured when a session is
opened and are not changed while the session exists. If you start without
To Next Page
Loading...
Need help?
General
