Emerson QuickPanel+ IC755C S12CD Series User Manual

Quick Panel Operator User Manual Section 5
GFK-2847AA Jan 2023
Mounting and Installation 57
Figure 54: Mounting Holes (all four edges) IC755CxS15CDx
5.4 Mounting and Installation Procedure
Observe the following guidelines to properly mount and install the
QuickPanel
+
Operator Interface:
Note: To order replacement gaskets, refer to the part number listed in Appendix B.
• The enclosure should be of metal material.
• The metal enclosure panel should ensure proper thickness and
rigidity suitable to minimize impact to the QuickPanel
+
unit.
• The recommended torque for the plastic back cover and interior
metal cover for the 10, 12, and 15” QuickPanel
+
display units that are
accessed for panel updates and serial port DIP Switches is 0.5 Nm (4.4
in-lb.).
• To avoid gasket degradation, limit repeated insertions or removals of
the unit and retightening of the mounting clips. For full protection,
always use a fresh gasket.
• The unit will not fit through the cutout with any cables connected, or
with the power supply plug inserted in the socket.
CAUTION
When installing the QuickPanel
+
into the panel, pay careful attention while handling the unit
so it does not drop and damage the unit.

Emerson QuickPanel+ IC755C S12CD Series Specifications

General

Brand	Emerson
Model	QuickPanel+ IC755C S12CD Series
Category	Monitor
Language	English