Quick Panel Operator User Manual Section 5
GFK-2847AA Jan 2023
Mounting and Installation 62
5.6 Battery Installation and Replacement
WARNING
Batteries may present a risk of fire, explosion, or chemical burn if mistreated. Do not crush,
disassemble, short-circuit, or dispose of in fire.
Use of batteries not specified for use with the QuickPanel
+
product may present a risk of fire
or explosion.
WARNING
Do not recharge, disassemble, heat, or incinerate lithium batteries.
Dispose of lithium batteries in accordance with federal, state, and local regulations. Be sure
to consult with the appropriate regulatory agencies before disposing of batteries.
CAUTION
1.
Replacing the battery should only be performed by trained personnel and in a non-
hazardous location.
2.
If the QuickPanel
+
Operator Interface is VESA mounted, detach from the VESA arm
when replacing the battery.
3.
The battery should only be replaced when the unit is powered off.
4.
Care should be taken to protect and insert the battery with the correct polarity.
5.
Do not use any metallic item to remove the battery (such as screwdrivers, knives,
pliers, and so forth).
6.
Be careful to not drop the battery or any associated screws into the unit.
7.
Be careful of edges on the internal sides of the enclosure and frame.
NOTICE
The PC controller does not start automatically when the battery is replaced in QuickPanel
+
Operator Interface. After battery replacement, start the controller using the #Command in
the PAC Machine Edition runtime.
To Next Page
Loading...
Need help?
General
