Quick Panel Operator User Manual Section 3
GFK-2847AA Jan 2023
Software 22
3.9.1 Firmware Upgrade
Note: This utility operates similarly to the QuickPanel
+
Update Tool, which comes with the OS image
upgrade binaries. The operator can continue to use the QuickPanel
+
Update Tool to use the DIP
Switch feature.
The Firmware Upgrade utility setting enables operators to upgrade the
firmware. Firmware updates are not supported over Ethernet or Serial
interfaces. Insert the media (SD Card) containing the required files for
firmware upgrade and perform the following procedure.
Note:
• Make sure the copy of the required binaries to the SD card is not within a folder.
• The firmware package contains encrypted .nbo files. Use the PreUpdate.exe tool to decrypt the .nbo
files before using them to upgrade.
After a firmware upgrade, which refreshes the device, the user must
download the project again and install their tools (including third-party
tools) on the device.
Note: It is recommended that the user back up any important data before firmware upgrade so that they
can replace the data after firmware upgrade if necessary.
NOTICE
If the current firmware build version on the QuickPanel
+
is any of the following, refer to the
following sub-section, Firmware Upgrade for Specific Build Version:
•
Build14_14B for IC755CxS06RDx (6” Display)
•
Build37_37D for IC755CxW07CDx (7” Display)
•
Build 26 for
IC755CxS10CDx (10" Display),
IC755CxS12CDx (12” Display), and
IC755CxS15CDx (15” Display)
To Next Page
Loading...
Need help?
General
