Section 9: Standard & Optional Machine
Features
130
Installation
The vector grid is designed to mate to the table so that your rulers and Home position
do not change. To install the vector grid, lower the table:
There are three mating pins on the bottom side of the vector grid.
There are three oval slots that are cut
into the rulers; two in the top ruler
and one in the left side ruler.
These three mating pins fit int
slots that are cut into the rulers
In addition to the three mating pins,
there are two pins to keep the vector
grid level. The two leveling pins are
at the front of the vector grid.
To Next Page
Need help?
General