Section 3: Getting Started
19
Connecting Electrical Power
What voltage should be supplied to operate a Zing laser?
All Epilog laser systems have an auto-switching power supply that detects the
incoming voltage and automatically switches itself to operate properly at any
single-phase voltage between 100 and 240 VAC. The power supply will also
automatically compensate for either 50 or 60 Hz.
Epilog supplies the appropriate power cord for all of our equipment. The
electrical cord is found in the accessory package with your machine. The power
cord for the laser plugs into the power receptacle located on the right side of the
machine in the rear corner. It is recommended that a dedicated 15 amp circuit be
used if available, but it is not required.
Zing Power Receptacle
To Next Page
Loading...
Need help?
General