Section 1: Safety
7
Safety Features and Regulatory
Compliance
Epilog has incorporated specific safety features into the Model 10000 Laser
System in order to meet the requirements of 21 CFR 1040 and the International
Standard IEC 60825-1. These safety features include:
A safety enclosure (cabinet), which fully encloses the engraving laser and
its beam path.
Dual redundant interlock systems that turn off the engraving laser when
the window is opened.
A visible emission indication when the Laser Diode Pointer (Red Dot
Pointer) is operating. There is an LED indicator on the machine’s front
panel.
21 CFR 1040 and IEC 60825-1 require that certification, identification, and
warning labels be placed on laser products. Reproductions of labels on the Epilog
Model 10000 Laser System follow, with their locations specified:
1. Certification/Identification Label: This
engraved plate is located on the rear of the
machine’s cabinet. The example shown is
for the Model 10000/25 product having a
16 inch by 12 inch (406 x 305 mm)
engraving area.
Patents
Pending
Date of Manufacture: October 2008
Epilog Corporation
16371 Table Mountain Pkwy.
Golden, CO 80403 USA
Class 2 Laser Product
This product complies with
21 CFR 1040.10 and 1040.11
except for deviations pursuant
to Laser Notice No. 50, dated
July 26, 2001.
This product complies with
IEC 60825-1: 2001.
Serial Number:
10035-0800061612
Model Number: 10000 Laser System
Mass:
45 kg max
To Next Page
Loading...
Need help?
General