Epson Disc producer PP-100N Security User Manual

107
Maintaining Your Product
Restoring to initial state
This section describes how to restore the product to the initial state.
There are two ways of restoring the product to the initial state as follows:
• Performing the operation on a PC
• Performing an operation with the product’s control panel
Performing the operation on a PC
1
Check that all jobs are finished.
See “Checking the job processing status” on page 72 in this guide for details on the check procedure.
2
Take out all the discs from Stacker 2.
3
Log in to EPSON Total Disc Net Administrator.
See “Logging in to EPSON Total Disc Net Administrator” in the PP-100N Security User’s Guide for the login
procedure.
4
Click the [Data] tab on the [Maintenance] screen.
• The product should be restored to the initial state by the administrator, and should not
be left unattended until the work is finished.
• Before starting work to restore the product to the initial state, perform a backup (see
“Backing up data” on page 104 in this guide) as necessary. Restoring the product to
the initial state deletes all of the set information, including the user information and
system settings, as well as all job history. The backup file can be restored (see “Restoring
data” on page 106 in this guide) after initialization is finished.
Even if the product is restored to the initial state, the product’s usage status data is not
deleted. See “Checking maintenance information” on page 111 in this guide for details
on the usage status.
Note
s

Epson Disc producer PP-100N Security Specifications

General

Brand	Epson
Model	Disc producer PP-100N Security
Category	Printer
Language	English