121
Copy Menu Settings to Another Projector (Batch Setup)
n
Disconnect the USB cable.
Indicator status Problem and solution
When all of the indicators start flashing, the settings are being written.
Writing the settings may have failed and an error may
When writing is finished, the projector turns off.
have occurred in the projector's firmware.
Stop using the projector, remove the power plug from
the electrical outlet. Contact Epson for help.
Caution
Do not disconnect the power cord from the projector while the file is being
written. If the power cord is disconnected, the projector may not start
correctly.
• Power: Blue - flashing
fast
gg Related Links
• Status: Blue - flashing
• "Batch Setup Error Notification" p.121
fast
• Lamp: Orange - flashing
fast
Batch Setup Error Notification
• Temp: Orange - flashing
The projector's indicators notify you if an error occurs during a batch setup
fast
operation. Check the status of the projector's indicators and follow the
instructions described in the table here.
Indicator status Problem and solution
The batch setup file may be corrupt, or the USB flash
drive or USB cable may not be connected correctly.
Disconnect the USB flash drive or the USB cable,
unplug and then plug in the projector's power cord, and
then try again.
• Lamp: Orange - flashing
fast
• Temp: Orange - flashing
fast
To Next Page
Loading...
Need help?
General
