141
Solving Image or Sound Problems
• "Supported Monitor Display Resolutions" p.153
Solutions When the Image Contains Noise or Static Solutions When the Image is Fuzzy or Blurry
If the projected image contains electronic interference (noise) or static, try the If the projected image is fuzzy or blurry, try the following solutions:
following solutions:
• Adjust the image focus.
• Check the cables connecting your computer or video source to the
• Clean the projector lens.
projector. They should be:
• Separated from the power cord to prevent interference
To avoid condensation on the lens after bringing the projector in
from a cold environment, let the projector warm up to room
• Securely connected at both ends
a
temperature before using it.
• Not connected to an extension cable
• No longer than 3 meters
• Position the projector close enough to the screen.
• Check the settings on the projector's Signal menu to make sure they match
• Position the projector so the keystone adjustment angle is not so wide that it
the video source.
distorts the image.
• If available for your video source, adjust the Deinteracing and Noise
• Turn on automatic adjustment in the projector's Settings menu.
Reduction settings in the Image menu.
s Settings > Keystone > H/V-Keystone > Auto V-Keystone
• Select a computer video resolution and refresh rate that are compatible with
• Adjust the Sharpness setting in the projector's Image menu to improve
the projector.
image quality.
• If you are projecting from a computer, press the [Auto] button on the
• If you are projecting from a computer, press the [Auto] button on the
remote control to automatically adjust the Tracking and Sync. settings. If
remote control to automatically adjust the tracking and sync. If any bands
the images are not adjusted correctly, manually adjust the Tracking and
or overall blurriness remain, display a uniformly patterned image on the
Sync. settings in the projector's Signal menu.
screen and manually adjust the Tracking and Sync. settings in the
• Select Auto as the Resolution setting in the projector's Signal menu.
projector's Signal menu.
• If you adjusted the image shape using the projector controls, try decreasing
• If you are projecting from a computer, use a lower resolution or select a
the Sharpness setting in the projector's Image menu to improve image
resolution that matches the projector's native resolution.
quality.
gg Related Links• If you connected an extension power cable, try projecting without it to see if
• "Input Signal Settings - Signal Menu" p.103
it caused interference in the signal.
• "Image Quality Settings - Image Menu" p.101
• If you are using the USB Display function, turn off the Transfer layered
• "Supported Monitor Display Resolutions" p.153
window setting in the Epson USB Display Settings program on your
• "Focusing the Image Using the Focus Ring" p.48
computer.
• "Cleaning the Lens" p.123
gg Related Links
• "Input Signal Settings - Signal Menu" p.103
• "Image Quality Settings - Image Menu" p.101
To Next Page
Loading...
Need help?
General
