Solving Remote Control Operation Problems
81
If the projector does not respond to remote control commands, try the
following steps until the problem is solved.
a
If you lose the remote control, you can order another one from Epson.
a
Check that the remote control batteries are installed correctly and have
power. If necessary, replace the batteries.
b
Check to see if a button on the remote control is stuck down, causing it
to enter sleep mode. Release the button to wake the remote control up.
c
If the image is projected from the projector, make sure you are
operating the remote control within the reception angle and range of
the projector.
d
Check the status indicator to confirm that the projector is in normal
operating status.
e
Strong fluorescent lighting, direct sunlight, or infrared device signals
may be interfering with the projector's remote receivers. Dim the lights
or move the projector away from the sun or interfering equipment.
f
If the pairing screen is displayed, perform pairing again by holding
down the [Enter] button and button on the remote control at the
same time for about three seconds.
gg Related Links
• "Remote Control Operation" p.24
• "Projector Indicator Status" p.74
• "Installing Batteries in the Remote Control" p.23
To Next Page
Loading...
Need help?
General
