Adjusting the Image
34
b
Use the up and down buttons to select
the aspect mode, and then press the
[Enter] button to confirm the
selection.
c
Auto may not be available depending on the type of input signal.
By normally selecting Auto, the optimum aspect is used to display the input signal. Change the setting if you
want to use a different aspect.
The table below shows the image projected on a 16:9 screen.
Aspect Mode Aspect Ratio for Input Signal
16:10 16:9 4:3
Normal
Full
Zoom
Adjusting the Sharpness
You can make the image clearer.
a
Press the [Menu] button to display
menus in the order Image -
Sharpness.
Remote control Control panel
The Sharpness adjustment screen is
displayed.
b
Use the left and right buttons to make
adjustments.
The image is enhanced when moved to the
right (positive) and softer when moved to
the left (negative).
c
Press the [Menu] button to exit the
menu.
To Next Page
Loading...
Need help?
General
