Configuration Menu
55
Function Menu/Settings Explanation
Operation
Direct Power
On
On, Off Sets up the projector so that projection starts as
soon as the power cord is plugged in without any
button operations.
Note that when this is set to On, projection starts
if power is restored after a blackout or other
power outage and the power cord is still plugged
into the projector.
Sleep Mode On, Off If the set time is exceeded and no signal is input,
the projector is automatically turned off and en-
ters standby mode. When in standby mode,
press the standby button on the remote control
or the control panel to start projection.
Sleep Mode
Timer
1 to 30 mins.
Sets the interval for Sleep Mode.
Illumination On, Off
Set this to Off if the light from the indicators on
the control panel bother you when watching a
movie in a dark room.
High Altitude
Mode
On, Off
Set this to On if you are using the projector above
an altitude of 1500 meters.
Language
- Selects the display language.
Reset
Yes, No
Resets all Extended settings except for Projec-
tion, High Altitude Mode, and Language.
Info menu
Function Menu/Settings Explanation
Projector Info
Lamp Hours Displays the cumulative lamp operating time.
Source Displays the current input source.
Input Signal Displays the input signal format of the current input source.
Resolution Displays the resolution.
Scan Mode Displays the scan mode.
Refresh Rate Displays the refresh rate.
3D Format Displays the 3D format of the signal input during 3D projec-
tion (Frame Packing, Side by Side, or Top and Bottom).
Sync Info Displays the image signal information.
This information may be needed if service is required.
Color Depth Displays the color depth and color difference.
Status This is information about errors that have occurred on the
projector.
This information may be needed if service is required.
Serial Number Displays the projector's serial number.
Version
Main Displays the firmware version of the projector.
Video2
To Next Page
Loading...
Need help?
General
