Useful Functions
45
c
•
If you are using a device or cable that does not support 3D images, 3D projection cannot be performed.
•
For details on 3D format settings on the AV device, see the documentation supplied with the AV device.
•
When the 3D format has not been correctly set up, an image will not be correctly projected as shown
below.
•
If a 3D image is not projected correctly even when a 3D format is set, the synchronization timing for
the 3D Glasses may be inversed. Inverse the synchronization timing using Inverse 3D Glasses.
s Signal - 3D Setup - Inverse 3D Glasses p.51
•
How a 3D image is perceived varies depending on the individual.
•
When you start projecting a 3D image, a notification about viewing 3D images is displayed. You can
turn off this warning by setting 3D Viewing Notice to Off.
s Signal - 3D Setup - 3D Viewing
Notice p.51
•
During 3D projection, the following Configuration menu functions cannot be changed.
Frame Interpolation, Aspect (Normal fixed), Overscan (Off fixed)
•
How the 3D image is viewed may change depending on the temperature of the surroundings and how
long the lamp has been used. Refrain from using the projector if the image is not projected normally.
Using 3D Glasses
You can view 3D images by using a pair of commercially available 3D Glasses (with an active shutter system
that supports radio waves (RF/Bluetooth) communication system).
To view 3D images, you first need to pair the 3D Glasses with the projector. See the User's Guide supplied
with your 3D Glasses for more information.
Notifications Regarding Viewing 3D Images
Note the following important points when viewing 3D images.
Caution
Viewing Time
•
When viewing 3D images, always take periodic breaks during extended viewing.
Long periods of viewing 3D images may cause eye fatigue.
The amount of time and frequency of such breaks varies from person to person. If your eyes still feel tired or
uncomfortable even after taking a break from viewing, stop viewing immediately.
To Next Page
Loading...
Need help?
General
