EasyManuals Logo
Home>Epson>Projector>EH-TW5800

Epson EH-TW5800 User Manual

Epson EH-TW5800
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
Troubleshooting
59
Indicators Status Remedy
(blue)
(orange)
High Temp Error
(Overheating)
The internal temperature is too high.
The lamp turns off automatically and projection stops. Wait
for about five minutes. When the fan has stopped, disconnect
the power cord.
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
If the air filter is clogged, clean it. s p.69
Make sure that nothing is blocking the area around the inlet
and that the temperature around the inlet is not too high.
s p.81
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the
electrical outlet. Contact your local dealer or the nearest Ep-
son repair center.
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Alti-
tude Mode to On.
s Extended - Operation - High Altitude
Mode p.54
Indicator status during normal operation
: Flashing : Lit : Off
Indicators Status Remedy
(blue)
Standby condition
When you press the standby button on the remote control or
on the control panel, projection starts after a short wait.
(blue)
Warm-up in progress
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is
warming-up.
Cool-down in pro-
gress
All operations are disabled while the projector is cooling-
down. The projector enters standby condition when cool-
down is complete. If for any reason the power cord is discon-
nected during cool-down, wait until the lamp has cooled
down sufficiently (about 10 minutes), reconnect the power
cord, and then press the standby button on the remote con-
trol or on the control panel.
(blue)
Projection in pro-
gress
The projector is operating normally.
c
When the projector is operating normally, the temperature and lamp indicators are off.
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
s Extended - Operation - Illumination p.54

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW5800 and is the answer not in the manual?

Epson EH-TW5800 Specifications

General IconGeneral
BrandEpson
ModelEH-TW5800
CategoryProjector
LanguageEnglish

Related product manuals