208
Setting Options Description
HDBaseT Connect ELPHD02
Control Communications
Extron XTP
Control ELPHD02: set to On to use the
optional HDBaseT control pad. Make
sure this setting is disabled if you are not
using an HDBaseT control pad.
Control Communications: enables or
disables communication from the
Ethernet and serial ports on the
transmitter; turning on this setting
disables the projector's LAN and RS-
232C ports (Control ELPHD02 and
Extron XTP must be turned off to use
this setting)
Extron XTP: set to On when you connect
an Extron XTP transmitter or switcher to
the HDBaseT port
HDMI EQ Setting 1
2
3
Adjusts the HDMI input signal level
depending on the devices connected to
the HDMI port. If there is a lot of
interference in the image, or if a problem
occurs, such as no image being
projected, change the setting.
Reset Signal I/O Settings Resets all settings on the Signal I/O
menu to their default values
Parent topic: Adjusting the Menu Settings
Installation Settings - Installation Menu
Settings on the Installation menu let you set up your projector for your installation environment. The
available settings depend on the currently selected input source and other settings.
To Next Page
Loading...
Need help?
General