17
Multimaster 260
Advanced SuperSwitch•
TM
technology makes multi-
process welding a breeze. Simplied setup makes it
easy to select Mig, Tig, or Stick
DC welding output from 15 to 300 amps; rated 260 •
amps at 50% duty cycle
Output Pre-Set Capability for Quick Set-Up•
Two Digital Meters for Easy Fine Tuning•
Heavy Duty Four Drive Roll Stand•
Convenient, Large Capacity Built-In Tool Box •
Dual “Easy-On” Cylinder Tray•
Industrial Ready-To-Weld Multi-Process Package
Ordering Information
SECTION 2 DESCRIPTION
The Multimaster 260 is a DC welding system designed for Mig (GMAW), Tig (GTAW) or Stick (SMAW) welding. In the Mig
mode this unit is capable of operating with short arc or spray arc transfer and handles both solid wires and tubular cored
wires. This unit is suitable for carbon steel, stainless steel, aluminum and many other alloys. It provides a power source
with built in wire feeder and undercarriage with provisions for two gas cylinders.
The following part number and description is for the Jesse James Series Multimaster 260 package.
Part Number - 0558004425, MultiMaster 260 230V Jesse James 15’ package
The following part number and description is for the basic Jesse James Series Multimaster 260 console (no accessories).
Part Number - 0558004424, MultiMaster 260 230V Jesse James console
PACKAGE CON TENTS (Standard Accessories)
Each Jesse James Series Multimaster 260 package includes:
P/N 0558004424, MM260 230V Jesse James console•
P/N 0558001649, 250 Amp “CC” 15 x 035-045 MST Gun•
P/N 21557, R-33-FM-580 Regulator / Flowmeter•
P/N 811FTF45, 87 HP HI Dep III .035•
P/N 811005313 5 lb. Stick Electrode Assortment •
P/N 13733936, Cable Plug (1/0 - 2/0)•
P/N 882F25, AF-1 Electrode Holder•
P/N 996995, Contact Tip MT M 035 (5)•
P/N 37290, Contact Tip MT M 045 (5)•
2.0 DESCRIPTION
To Next Page
Loading...
Need help?
General
