To Next Page

To Previous Page

Changing settings

24.1 General

You can change a variety of settings in the camera. You do this on the Settings menu.

The Settings menu includes the following:

• Recording mode.

• Connections.

• Camera temperature range.

• Save options & storage.

• Device settings.

24.1.1 Recording mode

The Recording mode is used to select:

• Single shot: This setting enables single shot mode. In this mode, you save an image by

pulling the trigger.

• Video: This setting enables video recording mode. For more information, see section

19 Recording video clips, page 90.

• Time-lapse: This setting enables time-lapse mode. For more information, see section

18 Programming the camera (time-lapse), page 89.

• Screening: This setting enables screening mode. For more information, see section 20

Screening alarm, page 92.

24.1.2 Connections

• Wi-Fi: This setting defines Wi-Fi networks. For more information, see section 22 Config-

uring Wi-Fi, page 95.

• Bluetooth: This setting defines Bluetooth connectivity. For more information, see sec-

tion 21 Pairing Bluetooth devices, page 94.

24.1.3 Camera temperature range

For accurate temperature measurements, you must change the Camera temperature

range setting to suit the expected temperature of the object you are inspecting.

Available temperature range options are dependent on the camera model. The unit (℃ or

℉) depends on the temperature unit setting, see section 24.1.5 Device settings, page 100.

#T810190; r. AI/41890/41890; en-US

FLIR E95 User Manual

Questions and Answers: