Handling the camera10
• Preview + Prompt for voice annotation: Display a preview image and the voice annota-
tion tool.
• Preview + Prompt for sketch: Display a preview image and the sketch annotation tool.
• Preview + Select annotation from menu: Display a preview image and the annotation
tool menu.
10.12.2 Procedure
Follow this procedure:
1. Push and hold the programmable button
. This displays the Programmable button
menu.
2. Push the navigation pad up/down to select one of the functions. Push the center of the
navigation pad to confirm.
10.13 Using the camera lamp as a flash
10.13.1 General
The camera lamp can be used as a flash for the digital camera. When the flash function is
enabled, the camera lamp will flash when an image is saved by pulling the trigger.
You can also turn on the camera lamp to use it as a flashlight.
10.13.2 Procedure
Follow this procedure:
1. Push the navigation pad to display the menu system.
2. Select
(Settings) and push the navigation pad. This displays the Settings menu.
3. Use the navigation pad to select Device settings > Lamp & laser.
4. Do one of the following:
• To enable the camera lamp function, select Enable lamp & laser and push the navi-
gation pad. To turn on/off the camera lamp, use the swipe-down menu, see section
8.4 Swipe-down menu, page 23.
• To enable the flash function, select Enable lamp & laser + Use lamp as flash and
push the navigation pad.
• To disable the camera lamp and flash functions, select Disable all and push the nav-
igation pad.
Note You can also assign the function Switch camera flash On <> Off to the program-
mable button
. For more information, see section 10.12 Assigning functions to the pro-
grammable button, page 37.
10.14 Hand strap
10.14.1 General
The upper part of the hand strap is attached to the camera by a bracket. There is one
bracket for the left side and one for the right side of the camera.
The lower part of the hand strap is threaded through the attachment point at the base of
the camera.
#T810190; r. AI/41890/41890; en-US
38