EasyManuals Logo

Ford Explorer 2011 User Manual

Ford Explorer 2011
448 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
programmed Car2U system buttons should be erased for security
reasons. Refer to Erasing the Car2U Home Automation System
buttons later in this section.
Read the instructions completely before attempting to program the
Car2U system. Because of the steps involved, it may be helpful to have
another person assist you in programming the transmitter.
Additional Car2U system information can be found on-line at
www.learcar2U.com or by calling the toll-free Car2U system help line at
1-866-572-2728.
Types of garage door openers (rolling code and fixed code)
The Car2U Home Automation System may be programmed to operate
rolling code and fixed code garage door openers.
Rolling code garage door openers were produced after 1996 and are
code protected. Rolling code means the coded signal is changed every
time your remote control garage door opener is used.
Fixed code garage door openers were produced prior to 1996. Fixed
code uses the same coded signal every time. It is manually
programmed by setting DIP switches for a unique personal code.
If you do not know if your garage
door opener is a rolling code or
fixed code device, open your garage
door opener’s remote control battery
cover. If a panel of DIP switches is
present your garage door opener is
a fixed code device. If not, your
garage door opener is a rolling code
device.
Note: Programming the Car2U system to a community gate will require
a unique set of instructions depending on the gate system model.
Contact the Car2U help line at 1-866-572-2728 to program your Car2U
system.
Note: Accidentally entering the program mode may override previously
programmed buttons. This can happen by pressing and releasing the
outer two buttons, or all three buttons, simultaneously. If this happens,
do not press any button until the module times out after approximately
2.5 seconds and resets to normal mode. When time-out occurs, all three
LEDs will flash rapidly for a few seconds then turn off. Any settings
should remain as previously set.
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
C
T
S
206-12 T
124
O
N
Driver Controls
116
2011 Explorer (exp)
Owners Guide, 3rd Printing
USA (fus)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ford Explorer 2011 and is the answer not in the manual?

Ford Explorer 2011 Specifications

General IconGeneral
BrandFord
ModelExplorer 2011
CategoryAutomobile
LanguageEnglish

Related product manuals