ment system. Blind Spot Assist is not active
during the setting proc
edure.
Troubleshooting
Please refer to at the start of the
chapt
er on page 180.
Fault in Blind Spot Assist system
Malfunction. The indicator lamp lights up
yellow. T
he yellow central warning lamp
also lights up.
1.
Go to a correspondingly qualified work-
shop.
No sensor visibility, fault message, sys-
tem switches itself o
— Clean radar sensors and remove stickers
or accessories from radar sensors
→ page 363.
— Check for any visible damage.
— If the problem persists, go to a corre-
spondingly qualified workshop.
The system behaves dierently than
expected
— The radar sensors are dirty → page 363.
The sensor visibility may be impaired by
dirt and snow or also residue from clean-
ing agents or coatings.
— The general conditions for system opera-
tion have not been met→ page 180.
— The radar sensors are covered by water.
— The vehicle is damaged in the area of the
radar sensors, e.g. caused by parking col-
lisions.
— The detection ranges of the radar sen-
sors are blocked by add-on parts, e.g. bi-
cycle carriers.
— Changes have been made to the paint-
work in the area of the radar sensors or
structural modifications have been
made, e.g. on the vehicle front end or the
running gear.
— Adhesive tinted films have been added to
the side windows aer delivery.
— If the problem persists, go to a corre-
spondingly qualified workshop.
Touch panels do not react as expected
Moisture, dirt and grea
se can impede the
functioning of the touch panels.
1. Always keep touch panels clean and
dry.
182 Driver assist systems
To Next Page
Loading...
Need help?
General
