any menus. Some warnings can be con-
firmed and hidden with the button
→ Fig. 1
4
1 .
S
electing a menu or information dis-
play
Vehicles with multifunction steering wheel:
1. Switch on the ignition.
2. Press the
→ Fig. 13 button, several
times if required, if a messa
ge or the ve-
hicle pictogram is displayed.
3. Press the
or button to display the
menus and to browse through a menu
→ Fig. 13.
4
. To open the menu or information dis-
play shown, press the
button
→ Fig. 13 or wait until the menu or infor-
ma
tion display opens automatically af-
ter a few seconds.
Vehicles without multifunction steering
wheel:
1. Switch on the ignition.
2.
Press the
→ Fig. 1
4
1 button,
several times if required, if a messa
ge
or the vehicle pictogram is displayed.
3. Hold down the rocker switch
→ Fig. 1
4
2 to display the menus
→ pa
ge 28 or to return to the menu se-
lection from a menu or an information
display.
4. To browse through the menus, press
the rocker switch
→ Fig. 1
4
2 up
or down.
5.
To open the menu or information dis-
play shown, press the
but-
ton → Fig. 1
4
1 or wait until the menu
or informa
tion display opens automati-
cally aer a few seconds.
Adjusting settings in menus
Vehicles with multifunction steering wheel:
1. Press the arrow buttons
or in the
displa
yed menu until the desired menu
option is highlighted → Fig. 13.
A frame appears around the selected
option.
2. Press the
button → Fig. 13 to make
the required changes.
A tick
indicates that the relevant
func
tion is switched on.
Vehicles without multifunction steering
wheel:
1. In the displayed menu, press the rocker
switch
→ Fig. 1
4
2 at the top or
bottom until the desired menu option is
marked.
A frame appears around the selec
ted
option.
2.
Press the
button → Fig. 1
4
1 to
make the required changes.
A tick indicates that the relevant
func
tion is switched on.
Returning to the selection menu
Vehicles with multifunction steering wheel:
1. Press the
or → Fig. 13 button.
V
ehicles without multifunction steering
wheel:
1. Select the Back menu option.
Button
on the multifunction steer-
ing wheel
— To switch between the current and previ-
ous menus, press the button
→ Fig. 13, → pa
ge 25.
— Press and hold the
button to show or
hide sec
ondary displays.
If warning messages about malfunc-
tions are displayed when the ignition
is switched on, it may not be possible to
adjust some settings or display information
as described. If the fault persists, go to
a correspondingly qualified workshop.
WARNING
If the driver is distracted when driving, this
c
an cause accidents and serious injuries.
·
Never operate the analogue instrument
cluster while the vehicle is in motion.
·
Always drive with your full attention
and responsibly.
Analogue instrument cluster 27
2KF012720AB
To Next Page
Loading...
Need help?
General
